HTW A3 Serie Manual De Usuario E Instalacion página 44

4. Operating Instructions
4. Operating Instructions
1、POWER (On/Off): The unit can be switched on or off. After boot, the current humidity will be
displayed with the defaults of continuous mode "CO", and the compressor will then start
immediately for dehumidification with POWER indicator lamp lit (when the compressor stops,it
flashes).
2、SPEED：Fan speed can be switched between high or low.
Note: In comfortable mode ("AU") when the room temperature is more than 27 degree, the wind
speed is fixed.
3、UP-DOWN（HUM+，HUM-）：Set the required humidity among the follows: "CO" (continuous),
"30%", "50", "35%", "40%", "45%", "50%"...... "85", "90", "AU" (comfort), "CO" (continuous) cycle.
The default mode is "CO".
Note: Press UP and DOWN at the same time to convert display of temperature or humidity, the
indicator "℃" being for temperature and "%" for humidity.
4、TIMER：Timing setting.
A、In the power-on state, press the TIMER key to set the timer for the scheduled shutdown. In the
off state, press the TIMER key to set the timer and when to start the dehumidifier.
B、Regular time range: 01~24 hours, timing setting: 00→01→02......→23→24→00 cycle.
C、When the timing is set to power on, the timing setting is completed and the timing is displayed.
When the timing is set to off, the timing setting is completed and the humidity is displayed after 5
seconds.
5、MODE key: mode conversion: dry clothes, fan, dehumidification；
6、Child lock: Long key This key is 5 seconds for child lock switch selection：
14