Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL ELEMENTS
Control elements - one and two zones
The control panel is shown in Figure 5. It is also shown below:
Single zone
Two zones
Press
to turn on the appliance. Press and hold the button for 3 seconds
to turn off the appliance.
Note: It will take about 3 seconds for all LED displays to turn off.**
Press
to turn the interior LED lighting on/off. Interior lighting is not
controlled by opening and closing the door.
To reduce energy consumption, LED lighting will turn off automatically
after 3-4 seconds.*
If you want the interior lighting to remain on, press and hold
seconds — the display will show "LP". After 4 seconds, the display will
show the temperature again and the light will be on until it is switched
off again. Press and hold
automatically after few seconds (recommended), The display will show
"LF". After 4 seconds, the display will show the temperature again and
the light will be on for only 3-4 seconds.
Set the temperature — single-zone refrigerator
Press
to increase the temperature in the chamber by 1°C*.
Press
to decrease the temperature in the chamber by 1°C*
•
The range of temperature that can be set varies between 5°C and
20°C.
•
The optimal temperature for wine storage is 12°C.
for 5 seconds to set the light is to switch off
- 13 -
for 5
Publicidad
