Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.17 SCAN Mode - Automatic switching between the paired Baby Units (Cameras)
You can set the SCAN (loop) mode and each paired Baby Unit will be displayed on the screen for 15 seconds and then the screen will
automatically change to the next paired Baby Unit.
•
Press and hold the CAMERA SWITCH button (11) to activate the automatic SCAN mode. A SCAN MODE ON message will appear on the screen
and a loop sign will appear next to the camera number on the top of LCD screen.
•
Press the CAMERA SWITCH button (11) to deactivate the Scan mode
4.18 Talk to Baby
•
Press and hold the
on your Parent Unit to talk to your baby or partner in the baby's room via Baby Unit.
•
Release the button when you are finished talking.
NOTE: While the "Talk to Baby" function is in use, there is no possibility to hear the sounds from the Baby Unit. Releasing the talk button allows
one to hear the sounds from the baby's room again.
4.19 Parent Unit Screen ON/OFF (Audio only mode)
•
Press the POWER button (1) to turn the LCD screen ON/OFF
5. Maintenance
All of the following maintenance procedures should only be performed when Baby and Parent Units are unplugged and off.
•
Clean the surfaces of the Baby and Parent Units with a soft, fluff-free cloth.
•
Never use cleaning agents or solvents.
•
If the units become dirty, use a lightly damp cloth to wipe surfaces, taking care not to allow water into any openings.
18
6. Troubleshooting
Problem
Possible cause/solution
No reception on the Parent Unit
•
The power adapters may not be properly connected.
•
Ensure that the Baby and Parent Units are ON.
•
Adjust the monitor antenna to vertical position.
•
Make sure the Baby and Parent Units are not far away from each other.
•
Baby and Parent Units may not be properly paired. Follow PAIRING instructions.
Interference or poor reception
•
Move the Baby Unit closer to Parent unit.
•
Use of other 2.4GHz products, such as wireless networks (Wi-Fi routers), Bluetooth
systems, or microwave ovens, may cause interference with this product, so keep the
baby monitor at least 5ft (1.5m) away from these types of products or turn them off if
they appear to be causing interference.
•
The Baby or Parent Units may be too close to metal objects.
•
The battery power may be too low.
Image frozen on the Parent Unit
•
Restart the Baby Unit (unplug the power adapter from the wall outlet, wait for approx. 5 seconds
and plug it back into the wall outlet).
•
Reset the Parent Unit by pressing the RESET button (17), located at the back of the Parent Unit,
under the stand.
A high-pitched sound is heard from the
•
The Baby Unit and Parent Unit may be too close to each other. Move them further apart.
units (feedback, static)
•
The volume on the Parent Unit may be set too high. Lower the volume.
Cannot hear the baby sounds on the
•
Volume setting on the Parent Unit may be too low. Increase the volume.
Parent Unit
•
Battery power may be too low. Recharge the battery.
EN
19
Publicidad
