Tripp-Lite NFI-U05A Manual Del Propietário página 10

Wiring Requirements
CAUTION:
• Use copper conductors only.
• W iring cable temperature should support at least 105˚C
(221˚F).
• The wire gauge for the terminal block should range between
12~24 AWG.
To insert the power wire and connect the 12~48V DC at a
maximum of 0.2A DC power to the power terminal block, follow
the steps below:
• Use a flathead screwdriver to loosen the wire-clamp screws.
• Insert the negative/positive DC wires into the ( - / +)
terminals, respectively.
• Tighten the wire-clamp screws to prevent the wires from
loosening.
ATTENTION: Use a power supply from 12~48V DC. The
device power shall be supplied by an LPS circuit.
10