Klarstein WONDERWALL 72 Manual Del Usuario página 21

OPERATION
To begin to use the heater, please follow these instructions:
1. Check the heater to be sure it is not damaged.
2. Then plug in it and then switch on the main illuminated ON/OFF switch on the side
of the heater.
There are two ways to use the heater:
(1) Power ON/OFF
When the product is powered on, the buzzer sounds once, and the product is in standby
mode. Press the ON/OFF button
window. If the set temperature is higher than the room temperature of 2 °C, the product
will automatically heat up, the icon ☼ will illuminate on window, and the indicator light
of heating on product will be on too.
(2) Week timer Mode
Start the heater in week timer mode: press ON/OFF button, when the icon 
disappears from window, press time button, then the timer and calendar icons ◷ flash.
How to set week timer
• Press or to adjust the day of the week, and then press the
confirm. Then „P1" flashes, press the
• Set the startup time, flash in hours, press
press the button to confirm. Then the minutes flash, press
minutes, and then press the set button
• Set the shutdown time, the same method as setting the startup time.
• Set the daily startup and shutdown time for P2, P3, and P4, using the same method
as for P1. P1, P2, P3, and P4 can be set to turn on or off at different time intervals
every day.
• After setting the week timer, wait until the display goes back to standby mode after
around 10 seconds. Press the
sure the two icons  and ◷ illuminate on the window at the same time, then the
product will work in week timer mode. If you want to change back to normal mode,
directly press , once more to go back to standby mode. And follow the above
instructions of Power ON/OFF mode.
on the controller, the icon  illuminates on
button again to confirm.
or to adjust the hour, and then
to confirm.
button once and then press the
button to
or to adjust the
button. Make
EN
21