Connecting And Disconnecting Transport Containers; Connecting; Disconnecting; Using The Transport Container Wall Hook - Tennant Orbio OS 3 Manual Del Operario

EN OPERATION
CONNECTING AND DISCONNECTING
TRANSPORT CONTAINERS
Quick−connect caps attach the transport
containers to the os3 generator and satellite
systems. The caps are color coded to ensure
correct installation. MultiMicro 200 connecting
caps are yellow, and MultiSurface connecting
caps are blue.
NOTE: Caps are designed to prevent access to
the concentrate solution. Do not attempt to
remove the caps from the container.

CONNECTING

Align section of cap with "L" shaped key on the
transport container. Push firmly until the cap locks
to the receptacle on the container.
ALIGNMENT KEY

DISCONNECTING

With thumb and forefinger, squeeze release tabs
on cap and lift cap away from transport container.
RELEASE TABS
26
USING THE TRANSPORT CONTAINER WALL
HOOK
Transport containers may be secured to the wall
with an os3 wall hook.
To remove a container from the wall hook, lift the
container up slightly and then away
To install the container on an os3 wall hook,
position the transport container immediately
above the wall hook and slowly lower the
transport container until the hook engages.
Note: Do not stack transport containers when on
wall hook.
For additional accessories and information
about Orbio satellite systems for the os3, see a
sales representative or go to www.orbio.com.
OS3 DM20036 (3−2014)