Publicidad
Idiomas disponibles
Idiomas disponibles
2. INSTALLTION
2.1 Location
When selecting a position for your unit you should make sure the floor is flat and firm,
and the room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker,
boiler or radiator. Also avoid direct sunlight as it may increase the electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly. This unit is not designed for use in a garage or outdoor installation. Do
not drape the unit with any covering.
When installing the unit, ensure that 10 cm of free space is left at both sides, 10 cm at
the rear and 30 cm at the top of the unit. This will allow cold air to circulate around the
wine cooler and improve the efficiency of the cooling process.
2.2 Reversing the Door Swing
1) Take off knuckle guard.
2) Take off top hinge with a screw driver.
3) Take off the door of refrigerating chamber
4) Take off middle hinge with a screw driver
5) Take off the door of freezing chamber
3
V .1
Publicidad
