Descargar Imprimir esta página

Johnson JRC1805FN1W Manual De Instrucciones página 24

Publicidad

Idiomas disponibles

Idiomas disponibles

2.3 Door Space Requirements
The unit's door must be able to open fully as
shown. W×D≥820×1070mm
W
2.4 Levelling the Unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the door and magnetic seal alignments
will not be covered properly.
Make sure that the foot touches the ground before use.
Look down from the top, clockwise and counterclockwise loosening, tightening.
2.5 Cleaning Before Use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with
warm water using a 'Wrung-out' sponge or cloth. Wash the shelves and salad bin in
warm soapy water and dry completely before replacing in the unit. Clean the exterior of
the unit with a damp cloth. If you require more information refer to the Cleaning section.
2.6 Before Using Your Unit
The refrigerator adopts 220~240V/50Hz AC power, voltage fluctuations over the range
of 187 ~ 264V will cause malfunction or even damage.
Do not damage the power cord under any condition so as to ensure safety use, do not
use when the power cord is damaged or the plug is worn.
Do not put flammable, explosive, volatile and highly corrosive items in the refrigerator to
prevent damages to the product or fire accidents.
Do not place flammable items near the refrigerator to avoid fires.
This product is household refrigerators and shall be only suitable for the storage of
foods. According to national standards, household refrigerators shall not be used for
other purposes, such as storage of blood, drugs or biological products.
Do not place items such as bottled or sealed container of fluid such as bottled
beers and beverages in the freezer to prevent bursts and other losses.
Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should
not be overfilled.
6
V .1

Publicidad

loading