Montipower MBX ULTIMATE ELECTRIC Manual De Instrucciones página 10

EN Operating instructions
5. Initial Operation
Before plugging in, check that the rated mains voltage and mains frequency, as
stated on the rating label, match with your power supply
Always install an RCD with a max. trip current of 30 mA upstream.
5.1 Attaching the Vibration absorbing handle
Always work with the Vibration absorbing handle (4) attached! Attach the handle on
the top or bottom side of the machine, depending on working position, and secure.
see Figure 4.
Figure 4
5.2 Attaching the Protective Cap
Always work with the Protective Cap (5) attached.
Installing:
Slide the Protective Cap (5) over the cams on the front end as shown below and
secure by tightening the screw on the side.
1
Figure 5
10
2
®
MBX ULTIMATE ELECTRIC
3