Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Operating instructions
3. General Safety Instructions
For your own protection and for the protection of your power tool, pay close
attention to all parts of the text that are marked with this symbol!
WARNING -
WARNING -
warnings and instructions may result in electric shock, fire and/or serious injury.
Keep all safety instructions and information for future reference. Ensure all users of
this tool have access to and have read these instructions.
4. Special Safety Instructions
4.1
Safety Warnings Common for the use of Rotary Impact Tool Operations:
a)
This power tool is intended to function as a Rotary Impact Tool. Read all safety
warnings, instructions, illustrations and specifications provided with this power tool.
Failure to follow instructions may result in electric shock, fire and/or serious injury.
b)
Only Rotary Impact Surface Preparation operations shall be performed with this
power tool.
create a hazard and cause personal injury.
c)
Only use MontiPower
Do not use accessories which are not specifically designed and recommended by the
tool manufacturer.
does not assure safe operation.
d)
Do not use a damaged MBX
e)
After replacement of the MBX
f)
After fitting accessories such as the Adapter System and MBX
Allen key / Torx wrench. Always ensure the Allen key / Torx wrench is removed prior
to switching on the tool.
g)
When placing the tool on a bench or on the floor, the label must always point upward.
h)
When not in use, disconnect the tool from the power supply and store in a suitable,
dry place to prevent unintentional or unauthorised use.
i)
Always hold the tool by the body and the vertical handle when in operation
®
j)
Use MBX
®
k)
The MBX
l)
If the tool suddenly feels different (level of vibration) or produces a different noise
(pitch), the tool should be shut down immediately and the accessories such
as the Adapter System, MBX
m)
Wear personal protective equipment. Always use a face shield,
safety goggles or safety glasses. As appropriate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stopping small abrasive or workpiece
fragments.
by operations. The dust mask or respirator must be capable of filtering
particles generated by your operation. Prolonged exposure to high intensity noise
may cause hearing loss.
6
Reading the operating instructions will reduce the risk of injury.
Read all safety warnings and instructions. Failure to follow all safety
Operations for which the power tool was not designed may
®
®
MBX
Belts and MontiPower
Just because the accessory can be attached to your power tool
®
Belt in the correct operating direction (Figure 3).
Belt can produce sparks when machining hard surfaces.
®
The eye protection must be capable of stopping flying debris generated
Belt or Adaptor System, inspect before use.
®
Belt, check Adapter System for correct assembly
Belt checked for damage.
®
MBX
ULTIMATE ELECTRIC
®
Adaptor Systems with this tool.
®
Belt, always remove
Publicidad
