Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Operating instructions
Figure 2
Figure 3
4.3
Additional Safety Instructions
WARNING
• Accessories must be stored and handled with care in accordance with the
manufacturer's instructions.
• The workpiece must lay flat and be secured against slipping, e.g. using clamps.
Large workpieces must be sufficiently supported.
• We recommend connecting a residual current circuit-breaker (FI) upstream.
When the tool is shut down via the FI circuit-breaker, it must be checked and
cleaned. See Chapter 9 for more information on cleaning the motor.
• Damaged, eccentric or vibrating tools must not be used.
• Disconnect the tool from the mains power supply before making any
adjustments, converting or servicing the machine.
• A damaged or cracked handle must be replaced. Never operate a machine with
a defective handle.
• A damaged or cracked hand guard must be replaced. Never operate a machine
with a defective protective cap.
8
– Always wear protective goggles.
®
MBX
ULTIMATE ELECTRIC
Publicidad
