Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
c. Make sure that the two mounting holes in the
guard are aligned with the two assembly holes
in the base of the gear case. Secure the guard
in place by tightening the two screws (N) with
a Phillips screwdriver (not included). See
Fig. 2b.
3. Mounting the Front-Assist Handle
a. Remove the battery pack from the trimmer.
b. Remove the screw knob (K) and the adjusting
lever (J) from the front-assist handle (I). See
Fig. 3a.
c. Mount the front-assist handle (I) on the shaft
as shown in Fig. 3a.
d. Insert the locking lever (J) into the front-assist
handle, and then tighten the screw knob (K).
Make sure that the front-assist handle faces
upwards so that it points toward the rear
handle.
e. Lower the locking lever (J) to secure the front-
assist handle (I) on the shaft so that it cannot
move during operating.
To Adjust the Front-Assist Handle Position
The handle should be positioned so that your arm
is straight when holding the trimmer by the front-
assist handle.
To adjust the front-assist handle (I) position,
remove the battery pack from the trimmer, lift the
locking lever (J) so that the front-assist handle
(I) can be moved to the desired position along
the shaft. Lower the locking lever (J) so that the
handle cannot move during operation (Fig. 3b).
2b
3a
3b
11
N
I
J
K
J
K
Publicidad
