Publicidad
Idiomas disponibles
Idiomas disponibles
To Start Engine
Be sure no one other than the operator is standing
near the lawn mower while starting engine or
operating mower. Never run engine indoors or in
enclosed, poorly ventilated areas. Engine exhaust
contains carbon monoxide, an odorless and deadly
gas. Keep hands, feet, hair and loose clothing away
from any moving parts on engine and lawn mower.
Refer to the Engine Operator's Manual for instructions on
starting and stopping the engine.
To Stop Engine
Release blade control to stop the engine and blade.
NOTE: If equipped with an electric starter push key,
remove the key when the mower is unattended to prevent
unauthorized operation.
Wait for the blade to stop completely before
performing any work on the mower or to remove
the grass catcher.
Check blade stopping time is within 3 seconds. If
blade does not stop within 3 seconds contact your
Service Center.
Using Your Lawn Mower
The operation of any lawn mower can result in
foreign objects being thrown into the eyes, which
can damage your eyes severely. Always wear
safety glasses while operating the mower, or while
performing any adjustments or repairs.
Be sure lawn is clear of stones, sticks, wire, or other
objects which could damage lawn mower or engine. Such
objects could be thrown by the blade in any direction and
cause serious personal injury to the operator and helpers.
BAIL DRIVE CONTROL
1. Once the engine is running, squeeze the bail drive
control against the upper handle to propel mower.
2. Release the bail drive control to stop mower from
propelling.
OPERATION
WARNING
WARNING
WARNING
SINGLE LEVER DRIVE CONTROL
1. Once the engine is running, squeeze the single lever
drive control against the upper handle to propel
mower.
2. Release the single lever drive control to slow down or
stop mower from propelling.
DUAL LEVER DRIVE CONTROLS
1. Once the engine is running and while continuing to
hold the blade control down, squeeze either (or both)
drive controls against the upper handle to propel
mower (Figure 30).
2. Release the dual lever drive controls to slow down or
stop mower.
3. Speed Control (if equipped) - To change speed, move
speed control to the desired speed.
NOTE:
When selecting a drive speed, use the first speed
until you are comfortable and familiar with the operation of
the mower.
IMPORTANT:
If you are shifting speeds while the mower
is stationary it may be difficult to shift into first speed
under certain conditions. This is easily remedied by briefly
engaging the drive lever.
NOTE: Your mower is equipped with an advanced internal
drive system for ease of use and smooth shifting. When
turning or pulling the unit rearward, you may notice
higher than normal resistance in the rear wheels under
certain conditions. This is perfectly normal and can be
remedied by allowing the unit to roll forward slightly
without the drive lever(s) engaged before pulling
backwards.
18
Engage the right, the left, or
both the right and left control
levers to propel the mower
Figure 30
Publicidad
