Bimar HC509 Folleto De Instrucciones página 19

To operate the heater: check that the thermostat knob is in pos."MIN", insert the plug into the
socket and select the desired functions described above.
To turn off the appliance, turn the thermostat knob to pos."MIN" and of the selectors in
pos.(●)and remove the plug from the socket.
Model with 24h timer, switches and with room thermostat regulation (type AMA04)
The heater is equipped with the following adjustment devices:
Switch (A) to turn on the fan (turbo function), turns on in pos.(
-
Switch (B) to adjust the power 750W = heat with low power consumption, turns on in
-
pos.(750) or turns off in pos.(●).
Switch (C) to adjust the power 1250W = heat with low power consumption, turns on in
-
pos.(1250) or turns off in pos.(●).
Switch (B+C) to adjust the power 2000W = immediate heat, turns on in
-
pos.(750+1250/2000W) or turned off in pos.(●).
The thermostat (D) regulates the appliance based on the surrounding ambient
-
temperature: it heats continuously until the set temperature is reached, and then it heats
only when the temperature decreases and for the period of time needed to bring it back
up to the set temperature.Use the respective knob: if turned fully in an anticlockwise
direction, the fan heater stays off (MIN), if fully turned clockwise it is set to the maximum
temperature (MAX); the heater runs at intervals when set to the settings in between.
- Slider switch (F): when the index is in position
"I" the appliance works, but the timer is
excluded,
in position " " the timer is active, in pos."0" the appliance is off.
24H timer (E): allows to adjust during the 24
-
hours, "on" and "off" periods of the fan heater,
and to repeat them systematically every day; it
is active when the slider switch (F) located
below is in correspondence with the symbol"
".When using the timer, first:
a) Set the correct time: turn the timer disc in the direction of the arrow,
matching the correct time to the reference marker.
b) The on/off functions are adjustable using the sliders on the disc: when
pushed to the centre, the appliance stays off, when pushed towards the outer
edge of the disc, it turns on; slide the slider button to position it in either
position (1 slider corresponds to 15 minutes).Adjust the position of the
sliders for the times of the day when the appliance must be on (slider to the
outer edge) or off (slider to the centre): at this stage, the on and off periods
can be seen in segments on the disc.
The timer will repeat the same functions until the settings are changed or for as long as the
button remains in the pos."
To operate the heater: check that the switch (F) is in pos."0", insert the plug into the socket
and select the desired functions described above.
Running the appliance without the timer (switch pos."I").
Running the appliance with the timer (swtich pos.
" and/or plug into the socket.
19
) or turns off in pos.(●).
).