Publicidad
Idiomas disponibles
Idiomas disponibles
(2) If the password is not correct: the display shows "no" and then
comes into the work state.
(3) If the password is correct: the display shows "SET" about 20
seconds.
a) During the 20s of displaying "SET": click "CH2" into the password
setting(refer to the password setting at the initial state) If input the initial
password "000", the system comes into the unlocking state. Or else, it
can set a new password.
b) During the 20s of displaying "SET": click "CH1" or "CH3" to exit the
password setting and come to the work state.
c) If don't do any operation during the 20s of displaying "SET": The
system comes into the work state.
(4) After setting new password and turn on the power switch, the display
will show "no" and then comes into the work state or sleep state.
NOTE: In the initial state, it can change the password directly and without input the
correct password "000" first.
After setting a new password in the initial state, it must turn off the power switch and
then turn on it, and then the locking function of the parameter setting comes to run. Or
else, it can change the parameter after changing the password.
2.7. Error Messages
1. Heater error: If there is some malfunction in the heater or in the
heater circuit, the temperature parameter of LCD will display "H-E".
It must test the heater and the correlative parts.
2. Sensor error: If there is some malfunction in the sensor or in the
sensor circuit, the temperature parameter of LCD will display "S-E"
and the power supply to the handle will be cut off.
3. ERR: If there is some malfunction in the fan or in the fan circuit, the
LCD will display "ERR" and it must test the fan and the correlative
parts.
8
USER MANUAL
Publicidad
