Powr-Flite Borelli Dual Pro Manual De Instrucciones página 14

MAINTENANCE
CAUTION: Unplug the vacuum cleaner before performing any of these steps.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the low position
Turn the vacuum over.
(see page 9).
2. Slide the clips toward each other
3. Remove the bottom plate.
How to Replace the Belt
1. Turn the unit over and remove the bottom plate
as described in the above section.
2. Remove the agitator by pulling it straight out.
3. Remove the belt from the agitator and motor
pulley.
4. Loop a new belt over the motor pulley and over
the end of the agitator.
5. Stretch the belt over the agitator while inserting
it back into the brush head housing.
6. Replace the bottom plate by hooking the
front end of the plate into the two ribs on the
front end of the brush head housing.
Press the bottom plate into place by sliding
the clips away from each other.
NOTE: To ensure maximum cleaning efficiency, check the belt regularly to ensure
it is in good condition. Replace the belt if it is stretched, cracked or if excessive
slipping is occurring.
How to Clean the Brush Head Hose
1. Remove the wand from the wand / hose holder as
shown on page 10.
2. Squeeze the tabs on both sides of the quick clean-out
port and pull away from the vacuum
3. Check above and below the port opening for
obstructions.
4. Remove any obstructions.
5. Replace the quick clean-out port by squeezing both
tabs and pushing it back into the wand / hose holder.
(Fig. 1).
(Fig. 2)
(Fig. 1).
Fig. 1
Fig. 2
Fig. 1
14