Publicidad
Idiomas disponibles
Idiomas disponibles
VIEW button:
When only 1 baby unit is registered, the VIEW button is
only used for closing the menu when the menu is opened.
When multiple cameras are registered to the parent unit,
you may press the VIEW button to select the following view
modes, as indicated in the upper right part of the display:
: the image of camera-1 is shown
1 1
: the image of camera-2 is shown
2 2
: the image of camera-3 is shown
3 3
: the image of camera-4 is shown
4 4
: the images of all registered cameras are shown one
after the other; each image remains visible for approxi-
mately 10 seconds
The unit does NOT automatically switch to a camera
where sound is being detected.
the images of all registered cameras are shown simul-
taneously
There's NO sound in this mode. You may press the
VIEW button several times to select the camera
you'd like to listen to.
The end of the following chapter describes how to register
and de-register additional cameras.
Temperature display:
The upper part of the display of the parent unit shows the
temperature in the room where the baby unit is located.
This display has a range of 0°C to 50°C.
Keep in mind that the displayed temperature is
indicative.
See the item Temperature alert in the next chapter for
setting the temperature alert.
Sound indicators:
The 9 sound indicators in the upper part of the screen flash
to indicate whether the baby is crying. In this way you can
also monitor your baby when the volume level is set to low
or turned off.
34
Publicidad
