Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Lighting the appliance using the piezo
• To light up the appliance using the piezo igniter, push and turn the control knob in an anticlockwise
direction until you hear a click. If the gas does not ignite on the first spark, turn the control knob back to its
"OFF" position. Try again, by pushing and turning the control knob anti-clockwise until you hear a click. If
the gas has not ignited in the first two to three seconds you should close the control valve by turing
the control knob back to its "OFF" position.
• Wait approximately thirty seconds to let any accumulated gas within the burner escape. Repeat the above
process if necessary until the flame ignites. The flame should normally light up within the first one to two
seconds.
Lighting up using a BBQ lighter
•
When starting cold, the appliance may be lit from the top prior to fitting the desired cooking surface onto
the fat pan. When lighting up a hot appliance, it is recommended that this be done by sticking a barbecue
lighter through one of the vent holes underneath the burner, until it is in line with the burner (DO NOT
place the BBQ lighter through the large hole directly underneath the burner). Ignite the BBQ lighter. Whilst
the BBQ lighter is lit, push and turn the control knob anti-clockwise to light the burner.
General
•
Once the appliance is lit, the fl ame intensity may be adjusted by turning the valve knob anti-clockwise to
reduce the flame, or clockwise to increase the fl ame.
•
The fully closed position is at the furthest clockwise position. To rotate the valve from the fully closed
position, it is necessary to first press the control knob in just enough to move out of the lock mechanism. While holding the control knob in,
turn it in an anti-clockwise direction. Once the spindle has moved out of the lock position it is no longer necessary to keep the control knob
pressed in and it can be rotated freely to the desired flame setting.
•
When cooking food with a high fat content, flaring may occur if the selected heat setting is too high. Should this happen, turn the heat down
until the flaring ceases.
•
The flame may be observed through the inspection hole provided for this purpose on the side of the fat pan.
•
After use, first close the control valve on the gas cylinder (if applicable). When the flame has gone out, close the control valve on the device
•
Do not move the appliance when in use. It is unsafe practice to move the appliance whilst lit and may cause flaring.
•
When not in use remove the gas cartridge
Cooking tips:
A feature of the Skottel BBQ is that it offers various heat zones (See Fig.5). This is very useful as some foods cook quicker than others and the
food that is ready first, can be moved to the cooler areas of the dish to keep warm whilst the balance of the food is still cooking.
NOTE! If the appliance is used in windy conditions, the dome must be used as a wind shield, and placed in position (as shown in fig. 6).
Locators
Only applicable to
8910-10, 8910-20,
8910-30, 8910-40,
8910-50, 8910-70
& 8910-80
Fig. 4
WIND
Fig .6
4 4
Push & turn left
to ignite.
Hot
Cool
Medium
Fig. 3
Fig.5
Publicidad
