Jimmy BX6 Pro Manual Del Usuario página 7

Cleaning and maintenance
Note:
1. HEPA filter is available for sale at JIMMY distributor.
2. It is recommended to clean the dust cup in time after each use. When there is too much dust to cause
HEPA blockage, it needs to be cleaned in time or replaced if necessary.
Cleaning of dust cup
Turn off the product, remove the dust cup
according to the instruction label on the dust cup;
Align the dust cup with the garbage can, press
the bottom cover release button, open the bottom
cover, and pour out the garbage. (Figure 1)
HEPA filter cleaning
Hold the dust cup with one hand and pull out the
filter assembly with the other hand.Turn HEPA
bottom cover clockwise; Take out the HEPA
assembly downward, tap the HEPA assembly
downward to clean the dust, or use a brush to
clean the dust and other debris on the HEPA
assembly. (Figure 2 -Figure 4)
After cleaning the dust cup and HEPA assembly,
put the HEPA into the filter assembly and then rotate it anticlockwise to fix it. After the "click"
sound is heard when rotating, and the HEPA is assembled in place without loosening.Then put
the filter assembly back into the dust cup and press it to the bottom, the dust cup assembly is in
place.
Note:
1. Do not miss HEPA filter!
2. If too much dust is accumulated in the dust cup, clean the dust cup and filter assembly with water, and wipe
them with dry cloth. Pay attention that HEPA filter need to be washed as less as possible. Clean the dust and
foreign matters on HEPA filter by tapping, and ensure that the dust cup and filter assembly are completely dry
before installation.
Brushroll cleaning and assembly
Note:
When cleaning the brushroll, be sure to disconnect the power supply to prevent the brushroll from starting by
mistake and cause human injury.
Turn off the machine, unplug the power supply, push the brushroll cover latch. Turn it from the
closed state to the open state, and then remove brushroll cover and take out brushroll. Clean
brushroll with cleaning brush. After cleaning the brushroll, install the brushroll and brushroll
cover back to mainbody in turn, and lock the brushroll latch. (Figures 5)
1
Bottom cover
release button
3
2
Filter
assembly
4
HEPA
filter
5