Jimmy BX6 Pro Manual Del Usuario página 8

Dust sensor cleaning
Dust sensor is installed inside of air inlet. Use
mini brush to clean inner wall of air inlet to avoid
too much dust accumulating on dust sensor and
cause abnormal display of dust level. (Figure 6)
Maintenance and Storage
Please clean dust cup and HEPA filter after each use for further use. It is recommended to
replace a filter after 30-50 hours of working time(depending on specific situation) for better use.
Any paper, lead glass, plastic will greatly affect the effect of UV light. Dust or stain on UV light
cover will affect the effect of UV light. Please wipe and clean the UV light cover regularly for
better use.
Do not touch the UV light cover as dirt will affect UV light effect.
Put the machine in cool and dry place if the machine is to be idled. Do Not leave it in direct
sunlight or humid environment.
Trouble Shooting
Please check the following trouble points before contacting after service.
Problems Possible Reasons
On/off switch is not pressed down
Product does
No power on socket
not turn on
Power cord is not firmly inserted
Air inlet blocked
Weak suction HEPA blocked
Cyclone blocked
Machine tilt and micro switch left
cleaning surface
UV light does
not work
UV light defect
6
5
Brushroll
Brushroll cover
Solution
Press down on/off switch
Check the socket
Check whether the power plug is
firmly inserted
Clean air inlet
Clean dust cup and HEPA
Clean cyclone
Machine tilting degree cannot ex-
ceed 30 degree
Contact after service to replace UV
light
6
Air inlet