Absaar S-M Manual Del Usuario página 12

The following contents are not specific to your device. They apply to all Absaar Consumer and Professi-
onal devices for a general-purpose description and understanding. Details of how to use your device are
provided on the device packaging.
Before starting the charging process, make sure that all switches on your charger have been set accor-
ding to the battery's specifications.
DESCRIPTION: AMPERAGE | VOLTAGE | CAPACITy
Ampere: Your device and its packaging show the maximum current value that the charge can supply to the battery. This de-
pends on the capacity of the battery you are going to charge. It decreases during the charging process.
Voltage: The voltage of the battery that you want to charge must correspond with the battery charger's voltage. Otherwise the
charger may not be connected to the battery. Connecting the battery to the charger when the voltages do not match will cause
battery damage.
Capacity: If the Ah rating of the battery falls within the Ah range of the charger, it is possible to fully recharge the empty battery
within 8 to 10 hours. If the battery has a higher Ah rating you may still charge it but the charging process will take significantly
longer.
8A | 12V | MAX 80 AH
INSTALLING THE BATTERy CLAMPS
1- Battery clamp (+), red:
Slide the red clamp insulation over the red (+) charger cable. Connect the charger cable to the battery clamp. Slide the clamp
insulation back over the battery clamp.
2- Battery clamp (-), black:
Slide the black clamp insulation over the black (-) charger cable. Connect the charger cable to the battery clamp. Slide the
clamp insulation back over the battery clamp.
12
APPLICATIONS
Depending on the capacity of your Absaar charger you may charge batteries of different vehicle
categories. The pictograms on the packaging illustrate the types of vehicle and battery types that
are compatible with your charger.
Caution: Only use your charger to charge batteries that correspond to the voltage and capacity of
your charger. Please check the technical specifications of your battery or contact your battery or
vehicle manufacturer in case of doubt. We assume no liability when charging unsuitable batteries.
CHARGING TyPE
Absaar manufactures two types of battery chargers: standard and automatic battery chargers.
Standard:
The charger must be disconnected from the battery once the charging process has finished.
Please monitor the charging process and stop it manually when the battery is charged. If the
charger remains connected to the battery for too long the battery will be damaged.
Automatic:
Once the charging process has finished, the charger will switch to trickle charge mode and does
not have to be manually disconnected from the battery.
The trickle charge mode allows you to leave the charger connected to the battery as long as you
want, making it the perfect choice for keeping the battery at a 100% charging level during the
winter season when not using the vehicle.
Connecting the charger to the battery poles (follow this sequence):
1. Connect the red battery clamp (+) to the positive (+) battery pole.
2. Connect the black battery clamp (-) to the negative (-) battery pole.
3. Use the power cord to connect the charger to a wall outlet.
To stop the charging process, perform the following steps in order:
1. Unplug the power cord of the charger from the wall outlet.
2. Disconnect the black battery clamp (-) from the negative (-) battery pole.
3. Disconnect the red battery clamp (+) from the positive (+) battery pole.
DIRECTIONS OF USE