PT-L1-Q3 6 m x 12 m
GB
Safety Instructions
Introduction
Congratulations on the purchase of your new product and welcome to TOOLPORT. Our customer service depart-
ment or authorised sales representative will be happy to answer your questions and give any valuable instructions.
Your new tent will give you freedom to plan many activities. It can be used at a party, to screen you from the sun-
light, as a shelter, for storage and in many other ways.
Please observe the instructions provided below in order to extend the useful life of your tent.
Important
Please read these assembly instructions before usage of the tent and keep it for future reference.
Safety
The tent was not tested for wind and snow learly indicated by the manufacturer. Therefore, these loads are not
covered by guarantee. Please watch the weather forecasts to be able to properly protect or disassemble the tent
before problems appear.
Warnings
Tents are intended for temporary accommodation and should be taken down in adverse weather conditions.
Always be sure to keep sufficient distance to hoses as well as gas and power lines to avoid possible damage.
Please check the area for power cables and gas lines. Ask your local autority for further information to avoid
damages.
When using suitable heaters (available e. g. in specialist shops), keep a minimum distance of 1.2 m to tarp material.
Open fire or heaters with open flames such as patio heaters, umbrella heaters, gas heaters etc. should not be used
in any case.
The person setting up the tent is responsible for adequately securing it to ensure its safety. Please check the
anchoring constantly to avoid damages. A stabil anchoring can extend the endurance of the tent.
Please wear head protection, gloves and solid shoes. The heavy metal parts could have sharp edges and could be
oily because of rust prevention treatment.
Please make sure that there is no permanent snow load. It should be removed right away. The same applies for
rain and other forms of load.
Children should not play with the spare parts of the tent. These components must be adequately protected.
Please find a flat and even ground base to pitch the tent. Only those materials provided with the tent can be used.
6