Publicidad
Idiomas disponibles
Idiomas disponibles
the event of the cable coming out
of its anchor.
The manufacturer will not be
Z
liable for any damage resulting
from incorrect or inadequate
installation.
Check that the mains power
Z
supply corresponds to the one
indicated on the identification
plate fixed to the inside of the
product.
Fixed electrical connections
Z
must incorporate the cut-out
devices envisaged by current
regulations.
For class I appliances, check
Z
that the domestic power
supply guarantees an adequate
earthing system.
Connect the suction hood to
Z
the flue using a suitable pipe.
Please refer to the accessories
to be purchased, indicated in
the installation manual
(for circular pipes: minimum
diameter 120 mm). The exhaust
pipe must be as short as
possible.
Connect the product to the
Z
mains using an omnipolar
switch.
The air venting regulations must
Z
be complied with.
Never connect the suction
Z
appliance to ducts carrying
combustion fumes (heaters,
fireplaces, etc..).
If the suction hood is used
Z
alongside non-electrical
appliances (e.g. appliances with
gas burners), it is necessary
to guarantee a sufficient level
of ventilation in the room, to
prevent any exhaust backflow.
When the cooking appliance
is used together with other
appliances using non-electrical
power sources, the negative
pressure in the room must not
exceed 0.04 mbar, to prevent
the fumes being sucked back
into the room by the cooking
appliance.
The air must not be discharged
Z
into a pipe that is also used as
a flue for appliances powered
by gas
or other fuels.
If the power cable is damaged,
Z
it must be replaced by the
manufacturer, by an authorised
service centre or by a qualified
technician, to avoid any risk of
danger.
Connect the appliance plug
Z
to a socket that complies with
23
Publicidad
