Publicidad
Idiomas disponibles
Idiomas disponibles
If the appliance is mounted
Z
on flammable materials, the
guidelines and regulations
relating to low voltage
installations and fire prevention
must be followed strictly.
For the fitted units, the
Z
components (plastic materials
and veneered wood) must be
mounted with heat-resistant
adhesives (min. 100 °C): the
use of unsuitable material and
adhesives may result in warping
and detachment.
The kitchen unit must have
Z
sufficient space to allow for
electrical connection of the
device. Wall-mounted units
above the device must be
installed at a sufficient distance
to leave the space required to
work in comfort.
The use of decorative
Z
hardwood borders around the
worktop behind the device is
allowed, provided the minimum
distance always complies with
the indications provided in the
installation drawings.
The minimum distance between
Z
the fitted device and the
rear wall is indicated in the
installation drawing for the
flush-fitted device (150 mm for
26
the side wall, 40 mm for the
rear wall and 500 mm for any
wall-mounted units above it).
To avoid any infiltration of
Z
liquids between the hob frame
and the worktop, position the
adhesive seal provided along
the whole outer edge of the
hob before installation.
Proper use
The suction hood has been
Z
designed solely to eliminate
cooking fumes during domestic
use.
Never use the appliance for
Z
purposes other than those for
which it has been designed.
Deep-fryers must be kept
Z
under constant supervision
when in use: the oil may catch
fire if it gets too hot.
Do not use the device with
Z
an external timer or separate
remote controlled system.
The device must never be
Z
installed behind a decorative
door, to prevent it from
overheating.
Never climb onto the device, as
Z
this may damage it.
Never place hot pots and pans
Z
on the frame, as this may
damage the silicon seal.
Publicidad
