Descargar Imprimir esta página

EuroLite LCC-18 UV Manual Del Usuario página 21

Publicidad

Idiomas disponibles

Idiomas disponibles

The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the device to your trussing system using an appropriate clamp.
For overhead use, always install a safety-rope that can hold at least 12
times the weight of the fixture. You must only use safety-ropes with quick
link with screw cap. Pull the safety-rope through the attachment eyelet
and over the trussing system or a safe fixation spot. Insert the end in the
quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is
defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten
the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
IMPORTANT!
EXTENSIVE EXPERIENCE, including (but not limited
to) calculating working load limits, installation material
being used, and periodic safety inspection of all
installation material and the device. If you lack these
qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger.
Improper installation can result in bodily injury and or
damage to property.
The device has to be installed out of the reach of
people.
If the device shall be lowered from the ceiling or high
joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the
room.
DANGER OF FIRE!
DANGER TO LIFE!
21/50
OVERHEAD
RIGGING
51841317_V_1_0.DOC
REQUIRES

Publicidad

loading

Este manual también es adecuado para:

Lcc-36 uv