MPM MBL-15M Manual De Instrucciones página 21

BEFORE FIRST USE
- To avoid injury and damage do not put hands or any items into the appliance when mixing. If it is
necessary to remove food residues, first switch off and unplug the blender and then use a rubber
or plastic spatula.
- The blades are very sharp. To avoid injury never place blades before correctly assembling jug and
bottle first.
- Tighten the jug mounting base.
- Always use the blender with bottle or jug.
- Always hold the jug during mixing.
- When mixing warm products remove the hole plug from the jug lid.
- Always start mixing at the lowest speed.
- To avoid burns always keep hands and face away from the hole in the jug lid.
DESCRIPTION OF THE APPLIANCE
1. Turn on/off knob – two operation
modes + PULSE function
2. Blender housing made of stainless
steel
3. Blender glass jug (1000 ml)
4. Handle
5. Stainless steel knife
6. Jug mounting base
ASSEMBLY OF THE JUG
1. Turn the jug (3) so that the base mounting hole is positioned upwards.
2. On the mounting base of the jug (6) put a gasket and a knife (5) in such a way that the fixing tongues
of the blade base are correctly seated inside the jug mounting base. Next turn the knife home
counter-clockwise.
3. Put the jug mounting base (6) with the knife (5) on the blender jug (3).
4. Tighten the mounting base to the blender jug paying attention to adjust the thread properly.
To disassemble the blender knife reverse the assembly procedure.
NOTE! Knives of the appliance are sharp. Handle them carefully.
USING CUP BLENDER
NOTE! Do not put or remove the blender jug while the appliance is running.
1. Place the blender housing (2) on a dry, hard and even surface.
2. After checking whether all parts of the jug are properly installed, place the jug (2) in such a way that
the  symbol on the base faces the  symbol on the blender housing (15).
3. Cut the products into smaller parts to make mixing easier. Put ingredients into the jug only when
the motor is stopped.
NOTE! Do not fill the jug above the mark of 1000ml (3).
4. Place the lid with the hole plug.
5. Plug the appliance into the power supply socket.
6. Turn it on with the knob (1), choosing one of two operating modes.
7. During mixing always hold the lid. If you need to add ingredients when the cup blender is running,
remove the hole plug from the lid (8) and feed the ingredients through the hole, and then replace
the plug (8).
7. Jug lid
8. Hole plug in the jug lid with scale
9. Blender bottle (600 ml)
10. Bottle cap
11. Bottle mounting base with knives
12. Closable opening
13. Holder
14. Non-slip feet
EN
21