MPM MBL-15M Manual De Instrucciones página 22

EN
8. When mixing is complete stop the appliance by turning the knob (1) to the <<0>> position and
unplug the power supply plug from the socket.
ATTENTION! Before pouring out the content of the jug wait until the knife stops rotating!
USING QUICK&EASY BLENDER
The appliance is equipped with two replaceable bottles of 600ml each (9) for preparing
and storing fresh fruit and vegetable cocktails, as well as milk and protein cocktails. Bottles
are made of top quality BPA free plastic. They have airtight caps (10) with a closable hole
for drinking (12) and a handle for carrying (13).
1. Place the blender housing (2) on a dry, hard and even surface.
2. Before use check the sealing rings in the cap (10) and the bottle base, (11) and make sure they are
correctly installed.
3. Cut the products into smaller parts to make mixing easier.
4. Put the ingredients into the bottle and tighten the mounting base with knives (11) paying attention
to the proper adjustment of the thread.
ATTENTION! Do not fill the bottle above the mark of 600ml. If the ingredients will produce a lot
of foam, do not put too much into the bottle. Suitably reduce the capacity.
NOTE! To maximize efficiency put ingredients into the bottle in the following order: liquids, fresh
ingredients, frozen fruit, yoghurt and ice cream.
5. Turn over the bottle and place it on the housing together with the mounting base. Press the bottle
and turn it home clockwise. Pay attention to the marks on the appliance (16).
ATTENTION! Knives of the appliance are sharp. Handle them carefully.
To disassemble the blender bottle reverse the assembly procedure.
ATTENTION! Do not use the appliance with an empty container!
6. Plug the appliance into the power supply socket.
7. Turn it on with the knob (1), choosing one of two operating modes.
8. When mixing is complete stop the appliance by turning the knob (1) to the <<0>> position and
unplug the power supply plug from the socket.
9. Remove the bottle (9) together with the base (11) from the blender housing (2).
10. Turn the bottle back into its normal position.
11. Twist off the bottle mounting base with knives (11).
12. Put the cap on the top of the bottle.
13. Open the plug in the bottle cap to use it and press it back to close and store.
NOTE! To mix some products, such as ice, use the PULSE function repeatedly. It is activated by
turning the knob to the left and keeping it there. Do not start the motor for more than 3 minutes,
because it may become overheated. After these 3 minutes stop the appliance and wait until it
cools down.
INSTRUCTIONS FOR USE
1. Boiled vegetables and fruit should cool down before putting them into the blender jug.
2. To avoid overloading or overheating switch to the highest speed when the appliance starts slowing
down.
3. Heavy sauce, paste, mayonnaise or other substances of similar consistency may be removed by
twisting off the jug base and pouring the contents on plates or into storage containers.
4. Fluid or semi-fluid substances, such as batter and light sauce, may be poured out over the top, after
the lid is removed.
5. Blender is not designed for the following:
- grating potatoes
- whipping eggs or dairy products substitutes
- mincing raw meat
22