Publicidad
Idiomas disponibles
Idiomas disponibles
APPLIANCE OVERVIEW
Unlike traditional vacuum cleaners, this bagless cyclone vacuum cleaner feature no bag for
collecting dust and debris. Instead, the appliance has a purpose-designed cyclone chamber, in
which air is forced to rotate in a vortex at an extreme speed. This creates a centrifugal force
which expels all dust and debris collected by the vacuum cleaner to a dust canister. The dust
canister is cleaned with ease. Using the cyclone vacuum cleaner saves time and reduces op-
erating costs of the appliance
1.
Vacuum cleaner canister
2.
Power cord winding button & carry-
ing handle
3.
Power switch with suction power
control
4.
Cyclone chamber & dust canister
release latch
5.
Cyclone chamber & dust canister seat
6.
Suction hose connection opening
7.
Power cord
8.
Grill release latches
9.
Cyclone chamber & dust canister
10. Dust canister handle
11. Cyclone chamber & dust canister lid
release latch
12. Cyclone chamber & dust canister lid
13. Cyclone chamber cone prefilter
STATIC ELECTRICITY
Vacuum cleaning certain surfaces at a low air humidity may cause slight electrification of
the appliance. This is natural, does not damage the appliance and does not constitute its
defect. To minimise this phenomenon, it is recommended to:
- frequently discharge the appliance by touching items in the room with the metal pipe,
- increase air humidity in the room,
- use generally available anti-electrostatic products.
APPLIANCE ASSEMBLY
1. Remove the vacuum cleaner from the box and discard all bags, stickers and fillers.
2. Check that the cyclone chamber, the dust canister and all filters are properly installed in place. See
the installation and removal instructions in Sections: "EMPTYING THE DUST CONTAINER" and
"AIR FILTER CLEANING AND REPLACEMENT".
3. Press and hold the latch on the suction hose mounting ring ⑳, insert the ring into the opening ⑥
and release the latch. To disassemble, press and hold the latch again and remove the ring ⑳ from
the opening ⑥.
4. Connect the other side of the suction hose ⑲ to the handle
wand ⑱ to the other side. Install one of the tools,
14. Motor sponge filter
15. Motor HEPA filter
16. Air discharge HEPA filter
17. Air discharge filter grill
18. Metal telescopic wand
19. Suction hose
20. Suction hose mounting ring
21. Suction hose handle
22. Floor and carpet tool
23. Parquet brush tool
24. Small turbo-brush
25. Slide-out crevice tool
26. Small multifunctional brush with
adapter
27. Accessories holder
28. Vacuum cleaner wheels
and connect the metal telescopic
,
, or
, on the end of the wand.
EN
23
Publicidad
