MPM MOD-25 Manual De Instrucciones página 26

EN
CLEANING AND MAINTENANCE
1. Periodically wipe clean the vacuum cleaner canister, the cyclone chamber and the dust canister
with a damp cloth. This will keep a neat appearance for a long time.
2. Do not clean with sharp objects or strong detergents (e.g. solvents), as they will cause permanent
damage to the vacuum cleaner canister.
3. Maintain the air filters as explained above.
TROUBLESHOOTING
Problem:
The cyclone chamber with the dust canister
cannot be placed in their seat.
Vacuum cleaner canister overheating.
Low suction power.
TECHNICAL DATA
Technical parameters are indicated on the product rating label.
Length of power cord: 6 m
Reach of vacuum cleaner: 9 m
NOTE! MPM agd S.A. reserves its right to modify the technical data.
Proper disposal of the product (waste electrical and electronic equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be dis-
posed with other type of municipal waste. Used equipment may have a negative impact on the environ-
ment and health of people due to potentially containing hazardous substances, mixtures and components.
Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may
cause a release of substances that are hazardous to the environment and health. Used equipment should
be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the
electric waste collection points, the user should contact the municipal point of electric waste collection or used
equipment processing department.
26
Possible causes:
The motor filters were not properly
installed.
A slight increase in the temperature of the vacuum cleaner canister is normal. If the
temperature is rising considerably, immediately turn off the vacuum cleaner and wait until
cools.
The air filters are very dirty.
The dust canister is full.
The suction hose and/or the telescopic wand
is clogged.
Solution:
Install the motor filters properly.
Clean or replace the filters.
Empty the dust canister.
Unclog the suction hose and/or the
telescopic wand.