Publicidad
Idiomas disponibles
Idiomas disponibles
PROPERTIES OF THE TOOL
The manual hammer drill is an ordinary electric tool, insulation Class II, which has been designed for drilling and hammering in
concrete, natural and artifi cial stone, marble, etc., using working tools with an SDS maxchuck system. The hammer drill permits
continuous adjustments of rotation of the spindle and by deactivation of the hammering action it permits drilling in such materials
as: wood, metal or plastics. A correct, reliable and safe operation of the tool depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual.
ACCESSORIES
The package provided by the manufacturer should contain:
- hammer drill
- additional handle
- drilling depth limiting device
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Rated speed
Max drilling diameter in concrete using a twist drill
Max drilling diameter in concrete using a crown drill
Impact energy
Impact frequency
Weight
Noise level
- sound pressure L
± K
pA
- power L
± K
wA
Vibration level ah
± K / ah
± K (impact drilling / forging)
,HD
,CHeq
Insulation class
Protection rating
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
Avoid contact of the power cable with heat, oils, sharp edges and moving parts. Damage or entanglement of the power cord
O R I G I N A L
EN
Unit
[V~]
[Hz]
[W]
[min
]
-1
[mm]
[mm]
[J]
[min
]
-1
[kg]
[dB(A)]
[dB(A)]
[m/s
]
2
I N S T R U C T I O N S
Value
YT-82131
220 - 240
50
1300
300 - 540
50
150
20
2900
9.7
95 ± 3
106 ± 3
20.93 ± 1.5 / 23.19 ± 1.5
II
IP20
11
Publicidad
