Storage Recommendations; Intended Use; Assembly And Adjustments - DeWalt DCS577 Manual De Instrucciones

b. Check to see if receptacle is connected to a light
switch which turns power off when you turn out the
lights;
c. Move the charger and battery pack to a location
where the surrounding air temperature is
approximately 65 °F – 75 °F (18 ° – 24 °C);
d. If charging problems persist, take the tool, battery
pack and charger to your local service center.
4. The battery pack should be recharged when it fails to
produce sufficient power on jobs which were easily
done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also
charge a partially used pack whenever you desire with
no adverse effect on the battery pack.
5. Foreign materials of a conductive nature such as, but
not limited to, grinding dust, metal chips, steel wool,
aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always
unplug the charger from the power supply when there
is no battery pack in the cavity. Unplug the charger
before attempting to clean.
6. Do not freeze or immerse the charger in water or any
other liquid.

Storage Recommendations

1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE

Intended Use

These heavy-duty circular saws are designed for professional
wood cutting applications. DO nOT use water feed
attachments with this saw. DO nOT use abrasive wheels or
blades. DO nOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty saws are professional power tools.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Saw Hook (Fig. D)

WARNING: To reduce the risk of serious personal
injury, Do not use the saw with the saw hook rotated
below the foot plate.

WARNING: To reduce the risk of injury from the saw
falling on operators or bystanders, make sure the saw
is supported securely when using the hook to hang the
saw from a rafter, joist or other elevated support.
Your saw has a convenient saw hook
saw to hang from a joist, rafter, or other suitable, stable
structure. The saw hook folds flat against the tool body when
not in use.
To use the saw hook, push down on the hook to rotate it
away from the handle until it latches into position.
To return the saw hook to its stored position, pull the hook
up until it latches against the tool body.
Fig. D
20

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: To reduce the risk of serious personal
injury, always wear ANSI compliant eye protection.
Cutting Depth Adjustment (Fig. A, E, F)
nOTE: The maximum depth of cut for this saw is 2-7/16"
(61 mm) at 90°.
1. Hold the saw firmly. Lift the depth adjustment locking
3
lever to move foot plate to obtain the desired depth
of cut.
2. Lower the depth adjustment locking lever and tighten
securely to lock the depth of cut before operating saw.
The length of cut markings on the side of the foot plate are
accurate at full depth of cut only. Setting the saw at the
proper cutting depth keeps blade friction to a minimum,
removes sawdust from between the blade teeth, results in
cooler, faster sawing and reduces the chance of kickback.
English
20
that allows the
9