SUHNER ABRASIVE LSA 70 Documentación Técnica página 12

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LSA
70.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with burrs and abrasives.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
08/2017.
M. Voyame/Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Use oiled compressed air (see also air quality un-
der section 2.3).
Observe national regulations.
2.1.1 m
ount the suPPly hose
Screw connection nipple into the valve body, invert suply
hose through connection nipple and fix it with hose clamp
(available as an accessory).
12
S
oteS on afety
ommISSIonIng
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the sleeve to the
«OFF» position! The tool may be switched
on only when the attachment have been installed correct-
ly.
2.2.1 t /t
urn on urn off
Turning on the machine by moving the sleeve in the ar-
row direction. Off by moving the sleeve in the opposite
direction.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 81dB(A), K=3dB(A)
Sound power level EN ISO 15744
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
Air hose ID
2.4 o
PerAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 t
ools
Use only clean tools!
max. 6.3bar
75W
3
0.20m /min
3
0.22m /min
1 drops/min
-1
80'000min
92dB(A), K=3dB(A)
2 2
1.69m/s , K=0.66m/s
2/4/4
0.160kg
Ø 5mm / 3/16"
/o
peratIon