Hoover H-FREE 500 Lite Manual De Instrucciones página 9

USING YOUR CLEANER
There are 4 working modes which you can detect from the colour of the Power Mode LED light.
• When you press ON-OFF button, the cleaner is ready to clean thoroughly with the main motorised nozzle. The LED light
is white. [3a]
• Press the Silent Mode button to clean thoroughly at the lowest noise level of this product. The light turns to green. [3b]
• Press the Turbo button to fully power the product for hard cleaning tasks. The LED light is blue. [3c]
• When you remove the nozzle or the tube, the product automatically adapts to a lower power for above floor cleaning, with
non-motorised tools. The LED light is light blue/cyan.
BRUSH BAR STATUS
The nozzle front LED light will stay illuminated white during all floor cleaning modes. It will flash 5 times when the safety
protection system is activated. [14]
SELECT SUITABLE ROLLER FOR BEST CLEANING
Intense Floor roller*: it is recommended to use on carpet which can go deep into the carpet to clean the dust.
Deep Care roller*: it is recommended to use on hard floor or delicate parquet. Thanks to the soft bristles you can gently
clean those type of floors.
IMPORTANT: Always switch off the cleaner before changing and cleaning the agitator.
NOTE: To fit the Roller you would like to use: [17]
1. Detach the agitator release button flap. It is positioned on the lateral part of the nozzle.
2. Hold the agitator release flap and pull down to remove the agitator.
3. Replace with Intense Floor Roller or with the Deep Care Roller.
4. Re-fit in position the agitator release flap.
WIPER BLADE ASSEMBLY
To obtain the best crevice and carpet performance, it is recommended to assemble the front and rear wiper blades to the
soleplate of the nozzle.
To do this, open the agitator release flap and remove the soft strip. Then grip one wiper blade, by inserting one end into
the rear slot and slide it in until fully home. Repeat these operations for the second wiper blade and slide it in the front slot.
Lock the agitator release flap. [16]
STORAGE FUNCTION
After use, your cleaner has 2 convenient storage methods.
1. WALL MOUNT STORAGE
Your product is supplied with a wall mount for convenient easy storage. Using the screws provided, fix the Wall mount to
your wall. After product use, simply place your cleaner into location. [2]
2. COMPACT STORAGE/PARKING MODE
To store the product on the tube, remove the handheld unit by pressing the handheld release button. [5]
Ensure the integrated 2in1 tool (Z) is returned to its original position as supplied ensuring the tool is located fully home
with the dusting brush and locating hook in the downward position.
Assemble the locating hook into the lower slot on the tube, and push the rear handle fully home into the locking mechanism
located at the top of the tube. [6]
SAFETY PROTECTION SYSTEM
To ensure the reliability of the product is not affected if used under arduous conditions, the product features two integrated
safety protection system. One on the cleaner and one on the nozzle.
NOTE: The Safety protection system will action in two conditions:
1. If there are obstructions in the air inlet or in the tube, the cleaner will be protected and turn OFF, and the LED light on
the main unit turns to red. If this happens simply check if there are any obstructions in the tube or in the air inlet on
the handheld. Remove it and switch ON again.
* Certain Models Only
4
GB