Voltr SNO2000WAC Manual De Instrucciones página 38

EN
MOUNTING THE STEERING CRANK
1
13
Remove the screw from the upper part of the
crank. Insert the crank support (D) in the upper
part of the crank. Then insert the lower part of
the crank in the upper part. Then put the screw
and tighten it.
3
Remove the pin (b), insert the lower part of the
crank to the place provided for this purpose and
put the pin (B).
38
D
B
2
12
Introduce the crank support into the hole in the
middle of the middle
12
(e), the brake washer (F) and the butterfly nut
(G) and tighten.
4
You can then test your crank by turning it from
left to right.
G
F
E
D
. Add the washer plate
27/03/2023