Probuilder 69370 Manual De Instrucciones página 26

Connection
a. Compressed air tool
b. Studs
c. Quick connector
d. Compressed air hose
e. Studs
f. Quick connector
g. Lubrication device
h. Regulator
i. Filter
j. Non return valve
k. Compressor
Use
Loading nails
Be sure that the air nailer is not connected
to the compressed air supply.
Press the magazine trigger (4) and open the
magazine(5).
26
Insert the required number of nails in
the magazine. The points must point
downwards and the feeder should push the
nails forward from behind.
Close the magazine. Check that it clicks into
place and cannot be pushed to one side
without pressing the release.
Setting nail depth
Connect the air nailer to the air supply,
and be sure that the supply air pressure is
correct.
Use the depthpressure setting button on
the air supply (h) to adjust the depth the
nail is to be driven into the item.
Check the depth is correct on a piece of
scrap wood before using on the item.
Use
Load the nails required and set the depth as
described above.
Grip the handle (l), place the gun on
the item so that the safety switch (6) is
depressed and press the trigger (3) to � re a
nail. Release the trigger.
Do not press the air nailer too hard.
Disconnect the air nailer from the air hose
after use.