Worx Sonicrafter WX686 Manual De Instrucciones página 11

The saw blade lasts longer if the wear is distributed evenly.
To ensure an even distribution, loosen the saw blade or
other accessory as applicable, rotate it and retighten
firmly.
Cut/Sand with a constant movement and light pressure.
Heavy pressure does not increase the cut/removal rate –
the accessory merely wears faster.
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, especially when used at
low speed, set the speed to maximum and run it with no load
for 2-3 minutes to cool the motor. Avoid prolonged usage at
very low speeds. Always keep the blade sharp.
Always ensure the work piece is firmly held or clamped to
prevent movement. Any movement of the material may affect
the quality of the cutting or sanding finish.
Start your tool before working and turn it off only after you stop
working.
Do not start sanding without having the sandpaper fitted.
Do not allow the sandpaper to wear away, it will damage the
sanding pad. The guarantee does not cover sanding pad wear
and tear.
Use coarse grit paper to sand rough surfaces, medium grit
for smooth surfaces and fine grit for finishing surfaces. If
necessary, first make a test run on scrap material.
Excessive force will reduce the working efficiency and cause
motor overload. Replacing the accessory regularly will
maintain optimum working efficiency.
MAINTAIN TOOLS WITH CARE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
Oscillating Multi-Tool
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Worx Sonicrafter
Type Designation WX686 WX686.X (6-designation of
machinery, representative of Oscillating Multi-Tool)
Function Sanding, sawing, rasping, scraping, polish-
ing
Complies with the following Directives:
2006/42/EC
2014/30/EU
2011/65/EU&(EU)2015/863
Standards conform to
EN 62841-1
EN 62841-2-4
EN 55014-1
EN 55014-2
EN 61000-3-2
EN 61000-3-3
The person authorized to compile the technical file,
Name: Marcel Filz
Address: Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2021/03/16
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
®
EN
11