Home Decorators Collection RENWICK 14435 Guía De Uso Y Mantenimiento página 10

Assembly — Hanging the Fan (continued)
5
Preparing the receiver and remote control
WARNING: To avoid possible electrical shock, ensure the
electricity is turned off at the main fuse box before wiring.
CAUTION: Do not use with a wall light dimmer switch.
If you feel you do not have enough electrical
NOTE:
wiring knowledge or experience, have your fan installed
by a licensed electrician.
This remote control unit is equipped with 16 code
combinations to prevent possible interference from or to
other remote units. The frequency switches on your
receiver (K) and remote control (L) have been preset at
the factory. Please recheck to make sure the switches on
the remote control (L) and the receiver (K) are set to the
same position. Any combination of settings will operate
the fan as long as the remote control (L) and receiver
(K) are set to the same position.
□
Insert the receiver (K) into the mounting bracket (B)
with the flat side of the receiver (K) facing the
ceiling.
10
L
K
K
B