Publicidad
Para restablecer la configuración de fábrica del auricular
•
Mantenga pulsadas simultáneamente
el modo de asociación.
Resolución de problemas
La remarcación no funciona
•
Compruebe que la lista de llamadas del teléfono no esté vacía.
•
Asegúrese de que se ha seleccionado el dispositivo de llamada correcto.
•
Asegúrese de que el teléfono u otro dispositivo es compatible con el perfil de manos
libres Bluetooth.
El auricular se apaga solo
•
La batería tiene poco nivel de carga. Sonará un pitido aproximadamente 10 minutos
antes de que el auricular se apague. Cargue la batería.
•
El auricular se apaga si se tarda más de 10 minutos en asociarlo con un teléfono.
Comportamiento imprevisto
•
Restablezca el auricular.
No hay conexión con el teléfono
Asegúrese de que el auricular está cargado y dentro de la cobertura del teléfono. Se
recomienda mantener una distancia máxima de 10 metros (33 pies) sin objetos sólidos
entre medias. Compruebe o vuelva a establecer los ajustes de Bluetooth en el teléfono.
Vuelva a asociar el auricular con el teléfono.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Any change or modification not expressly approved by Sony may void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Statement
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Esta es una versión para Internet de esta publicación. © Imprimir sólo para uso privado.
y la tecla de gestión de llamadas durante
7
Publicidad
