Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE CONTROLS
FAN
Pressing the FAN button cycles the circulation
fan speed from low (F1) to medium (F2) to high
(F3).The selected fan speed will
be shown in the LCD display.
The function can be used in
either COOL ,HEAT or FAN
modes.
When changing fan speeds, there is a brief
delay before the fan motor changes speed.
/
(TEMP/TIMER)
In COOl , DRY and HEAT modes, the
buttons adjust the set temperature up to 86°F or
down to 60°F , in one degree
increments. The temperature can
be switched between degrees
Fahrenheit and degrees Celsius,
pressing the
at the same time,or pressing °C
remote.
When the TIMER function is selected, use the
/
(TEMP/TIMER) buttons to adjust the delay
time from 1 to 24 hours, in one hour increments.
If you press and hold the
buttons, the set temperature or time will change
automatically after a few seconds.
NOTE: The displayed temperature is the SET
t
emperature, not the room temperature. In COOL,
ENERGY SAVER or HEAT mode, the thermostat in
DRY,
the air conditioner will run the compressor until the
set temperature is reached, then cycle the
compressor on and off to maintain the set
temperature.
/
(TEMP/TIMER)
button and
button
°F button on the
/
(TEMP/TIMER)
H O W T O U S E
TIMER
When theTIMER function is selected, you can set
the air conditioner to either automatically turn
OFF or turn ON after a delay of
up to 24 hours. The display will
show 0. Use the
buttons to adjust the delay
time from 1 to 24 hours, in one
hour increments.
To set an automatic off delay, press the TIMER
button while the air conditioner is running and
use the
/ (TEMP/TIMER)
delay time. The air conditioner will automatically
turn OFF after the set delay.
To set an automatic on delay, press the TIMER
button while the air conditioner is off and use
/ (TEMP/TIMER)
the
buttons to adjust the
delay time.
The display will show the number of hours
remaining until the unit is set to come on. The
air conditioner will automatically turn ON
after the set delay.
If you want to know how many hours you have
set, press the TIMER button and then you can
see the time through the LCD display.
If you want to change the set timer, press the
TIMER button and adjust the time when the
number is flickering.
To cancel the Timer function, press the TIMER
button and adjust the number to 0 when the
number is flickering, then the function will be
canceled in a few seconds.
Another better method is press the TIMER
button and press this button again when the
number is still flickering.
NOTE: Do not unplug the air conditioner when
using the timer function.
/ (TEMP/TIMER)
buttons to adjust the
11
Publicidad
