Publicidad
Idiomas disponibles
Idiomas disponibles
1. Screws (4 pieces)
2. Base
3. Main body
4. Control panel
5. Motor shaft
6. Oscillation knob
7. Safety screw
8. Front grille
1. Mount the base on the main body fixing it with the 4 screws
provided as shown in figure.
2. Unscrew the locking ring of the rear grille (11) from the
motor shaft (5) by turning it counterclockwise.
3. Insert the rear grille (12) on the motor shaft (5) making sure
that the handle on the back is facing upwards and the locking
pins (A-B) are in the vertical holes of the rear grille. Screw the
locking ring (11) by turning it clockwise.
4. Insert the fan (10) on the motor shaft (5) and fasten the
proper lock ring (9) by rotating counterclockwise.
5. Open the clips of the front grille (8) and place it on the back
grille (12) making sure that the logo on the central stud is
placed horizontally, parallel with the floor.
6. Find the proper position to lock the clips and insert the safety screw of the grille (7).
(EN) ASSEMBLING
9. Lock ring of the fan
10. Fan
11. Lock ring of the
back grille
12. Back grille
13. Motor
A-B. Locking pin for the rear grille
9 / 37
Publicidad
