Tecfrigo SINFONIA GN DRY Manual Del Usuario página 8

3
. Ensure that there is no danger of explosion (AD) in the room. . Make sure the environment is suitable
for the power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use.
5
. Insert the plug in the socket (do not use three-way adapters and reduction adapters).
I
equipment has been transported or stored overturned, let is rest in its correct position for at least 3 hours
before hooking it up to the mains.
UK
7. CONTROLS
D
The appliance features controls situated in a protected panel on the front side.
the temperature in the appliance.
E
3. Heating lamp switch:
cover - Position II to lift - Position O to stop - Position I to lower.
F
lamps off ten minutes before lowering the cover. Press button
temperature set-point, which can be changed by pressing button
NL
2).
8. CHECKING CORRECT OPERATION
P
Make sure that: 1
4.
heating lamps are on; . Check that the set temperature is correct. . Keep the machine away from
S
inflammable material or any danger of explosion.
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
Operator's guide
2. Basin resistor switch:
to switch on the heating lamps.
2
. plug is connected; . cover is open; . resistor switch is on (green light lit up);
5
4
to switch on the resistors of the basin.
4. Cover lifting switch: t
N.B.: turn the heated shelves and heating
8 "SET or P"
once to display the
9 "UP"
or button
3
6
6
N.B.:
if the
1. Thermostat: t
o adjust
o open and close the
10 "DOWN"
(see fig.