GYS GYSFLASH 30-12 HF Manual Del Usuario página 14

Shortcut to Lock Showroom :
The «Lock Showroom» feature can be activated without accessing the configuration menu.
• Turn OFF the device (main switch in the OFF position)
• Press MODE key
• Turn ON the switch, while the MODE key is still pressed. The screen displays «GYSFLASH 30-
12 HF Vx.x» for 3 seconds.
• Hold the MODE key until the creen displays «lock showroom: Y»
• Cables calibration :
This mode must be used each time the cables are changed. The GYSFLASH can be fitted with cables up to
2x5m in 16mm².
OK : The calibration was successful.
FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.
Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.
• ADVANCED MENU (code 1-9-6-4) :
This menu is intented for experimented user only.
To access this menu, enter in the code above («Select» key to change the digit selection and «Start/Stop» key to
confirm the code).
For more details, see page 15.
• Reset Memory (code 1-9-6-4) :
This menu is intented to factory reset the charger
settings by entering the code above. Any personal
parameters are deleted.
14
GYSFLASH 30-12 HF
RESET MEMORY
RESET MEMORY
Error Code
RESET MEMORY
Code: 0000
Code NOK
Code OK
(1964)
Display 1s
RESET MEMORY
Code OK
RESET MEMORY
Reset all ?
EN
MODE
0
1
...
9
Change the
code number
Yes
No