Hach WDMP sc Manual Del Usuario página 3

Table of Contents
1 Specifications on page 3
2 General information on page 4
3 Installation on page 9
4 Startup on page 18
Section 1 Specifications
Specifications are subject to change without notice. The specifications that follow are for the junction
box (Table 1) and the WDMP sc panel
analyzer, controller, turbidimeter and probe sensor specifications.
Specification Details
Power requirements 100 to 115/230 VAC, 50/60 Hz
Power consumption 90 VA maximum for CL17 analyzer
24 W maximum for all other electronics
Protection class I
Installation category II
Pollution degree 2
Altitude 2000 m (6562 ft) maximum
Fuse 5 x 20 mm, T 1.0 A, 250 V (2x)
Storage temperature –20 to 60 °C (–4 to 140 °F)
Conduit hub ½ NPT
Communications RS485 Modbus
Humidity Maximum relative humidity 80% for temperatures to 31 °C (88 °F), decreasing linearly to
50% relative humidity at 40 °C (104 °F)
Specification
Dimensions (W x H x D)
Weight
Operating temperature
Sample flow rate
Sample pressure
Sample temperature
Sample inlet connection
Sample waste drain connection ¾-in. ID hose barb
Sample waste drain pressure
Pressure sensor
5 Operation
6 Maintenance
7 Troubleshooting
8 Replacement parts and accessories
(Table 2). Refer to the instrument user manuals for the
Table 1 Junction box
Table 2 WDMP sc panel
Details
81 x 122 x 30.8 cm (32 x 48 x 12.1 in.)
54.4 kg (120 lb)
5 to 40 °C (41 to 104 °F)
0.4 to 0.6 L/min
138 to 862 kPa (20 to 125 psi)
5 to 40 °C (41 to 104 °F)
½-in. OD tube
Ambient, free-flowing (atmospheric)
Stainless steel (17-4 PH), Input: 7–35 VDC; Output: 4–20 mA, 0–1034 kPa
(0–150 psi)
on page 19
on page 19
on page 22
on page 22
English 3