Rohde & Schwarz UD1065 Manual De Instrucciones página 29

®
R&S UD1065
4.1.2 RF In / Out
The "RF In / Out" connector is a WR15 waveguide connector.
In the context of the IEEE 802.11ad test system, this connector either receives
the signal from the DUT (RF input), or provides a signal to the DUT (RF output).
Both directions are necessary for IEEE 802.11ad signal testing, depending on
whether a downlink or uplink signal is tested.
Risk of instrument damage
Make sure not to overload the RF input and keep within the maximum
allowed signal levels. Refer to the datasheet for the maximum allowed sig-
nal levels.
4.1.3 LO In
The "LO In" connector is a female SMA connector. It receives a signal from a sig-
nal generator used as a local oscillator (LO).
In the context of the IEEE 802.11ad test system, the R&S SMW200A is the exter-
nal LO. The signal is output by the RF output of the signal generator and fed into
the R&S UD1065 through the "LO In" connector.
Risk of instrument damage
Make sure not to overload the "LO In" connector and keep within the maxi-
mum allowed signal levels. Refer to the datasheet for the maximum allowed
signal levels.
4.1.4 Status Lights
The R&S UD1065 has two status lights.
The status light labeled "Power" turns green when you turn on the R&S UD1065.
Getting Started 1178.4176.02 ─ 02
Instrument Tour
Front Panel
14