Rohde & Schwarz UD1065 Manual De Instrucciones página 31

®
R&S UD1065
4.2.2 USB Port (SMW Control)
The male USB port (type B) labeled "SMW Control" is the interface to which you
connect the R&S SMW200A.
4.2.3 USB Port (RTO Control)
The male USB port (type B) labeled "RTO Control" is the interface to which you
connect the R&S RTO2044.
4.2.4 Analog I/Q Input
The four female SMA connectors receive a differential analog I/Q signal.
In the context of the IEEE 802.11ad test system, these connectors receive the
modulated wideband signal generated by the R&S SMW200A.
4.2.5 Ref Out
The "Ref Out" connector is a female SMA connector that provides a 100 MHz ref-
erence signal.
4.2.6 Trigger In
The "Trigger In" connector is reserved for future use.
4.2.7 Trigger Out
The "Trig Out" connector is a female SMA connector. It provides an RF power
trigger signal. The signal is TTL compatible.
4.2.8 Ref In
The "Ref In" connector is a female SMA connector that receives an external refer-
ence signal.
In the context of the IEEE 802.11ad test system, you can synchronize the
R&S UD1065 with the 10 MHz reference of the R&S SMW200A.
Getting Started 1178.4176.02 ─ 02
Instrument Tour
Rear Panel
16