LEMANIA ENERGY T13 Manual De Instrucciones página 14

To view stored results, select the 'Magnifying Glass' symbol on main menu
18.
Navigate through the results to view each test and if necessary, print the results
a.
To remove stored test data, just select the 'Dustbin' symbol in the settings menu.
19.
Navigate through the tests and delete each test as necessary
a.
The SD card can be inserted or removed on the right side of the tester. Please make sure you insert it upside
20.
down as indicated on the tester. Never force the card in the slot. To remove it, use a small pin to press on it.
Powering on the Device
To power on the T13 the clamps must be connected to the battery terminals. Turn the T13 on by connecting the red
clamp to the positive (+) terminal and the black clamp to the negative terminal (-). The T13 will display the battery
voltage and will then proceed to the home screen once a key is pressed.
Welcome Screen
Performing a Battery Test
When a vehicle has been running the battery will carry a surface charge. In order to correctly test the battery, the
surface charge must be removed by turning the headlights ON for 30 seconds with the engine off. Leave the battery
at rest with the ignition OFF for at least 60 seconds before testing the battery.
:
Note The maximum cranking current of a battery tested in motorcycle mode is 600A
The maximum cranking current of a battery tested in car mode is 2000A
In motorcycle mode, only the battery test is available. In car mode, all tests are available.
Use the directional keys to
select <Test> and press enter
Indicates which
File is open


Use the directional keys to
select the vehicle
Indicates if the SD card has been inserted
Home Screen

Use the directional keys to
select the required test
Current time
Page 14 of 60