Leica CINE 1 Instrucciones Abreviadas página 10

CHANGING THE BATTERIES
Please note the information provided in the section "Safety Remarks" for the
handling of batteries.
▸ Press the marking on the underside
• The battery compartment unlocks.
▸ Slide open the battery compartment cover as shown in the illustration
▸ Insert two AAA batteries
• Ensure correct battery polarity.
▸ Slide closed the battery compartment cover as shown in the illustration
Note
• The remote control should not be used if it is very warm or even hot.
REMOTE CONTROL WORKING RANGE
The remote control operates correctly up to a distance of 8 m / 26 ft from the
Laser TV. At a distance of 6 m / 20 ft, the remote control can be tilted to an
angle of ±30° (horizontal) or ±15° (vertical). This angle is covered via infrared
if the remote control was not paired.
PAIRING THE REMOTE CONTROL
▸ Switch on the device
▸ Keep the remote control within a 3 m / 10 ft radius of the device
▸ Press and hold the button and the
least 3 s
• The pairing process will begin.
• A message will appear in the display area to indicate whether pairing was
successful or unsuccessful.
Notes
• In case of an unknown error in the remote control, the reason could be a
connection error. A new pairing attempt may resolve the cause of the error.
• In case of an unknown error in the remote control, the error may sometimes
be resolved by removing the batteries and then pressing and holding any
button for 1–2 s.
• Pairing will not be successful if the Laser TV is in standby mode.
button at the same time for at
BEFORE INITIAL USE
New products and materials may release chemicals into the air through evapo-
ration. For the initial first few hours of operation, the device can therefore gen-
erate some odor. This is caused by some of the device components heating up
for the first time. All materials used fully comply with environmental require-
ments and regulations. The vapors responsible for the odor will diminish over
time.
We recommend running the machine in a well ventilated environment for some
time before its actual initial use.
MOUNTING THE SCREEN
Check the user manual of the product for information.
SETTING UP THE DEVICE
• This device should always be transported by two people.
• When handling the device, it must always be assured that the lens is pro-
tected.
• We recommend plugging in all cables on the back of the device before plac-
ing it in its final position.
• Ensure that all cables are plugged in correctly and in their correct ports.
• Loose cable connections can impact negatively on the image quality.
PICTURE GEOMETRY
Follow the steps below to align the picture of the Laser TV on the screen.
Afterwards, you can still apply a geometric correction as a final tweak. The
recommended sequence is as follows:
1. Align the lower edge of the image horizontally
2. Align the lower edge of the picture on the screen
3. Align the lower edge of the image to the width of the screen
4. Align the upper right corner
5. Align the upper left corner
6. Align the top edge of the image to the width of the screen
Attention
Never look directly into the lens while the device is operational. Never look
directly into the emitted light beam! Doing so may cause severe damage to
your eyes or permanent blindness!
Notes
• The dotted line depicts the position before alignment, the dark area the
position after alignment.
• Use the wrench supplied for turning the adjustment feet in or out.
• We recommend turning the adjustment feet all the way in before beginning
the alignment.