Descargar Imprimir esta página

Leica CINE 1 Instrucciones Abreviadas página 12

Ocultar thumbs Ver también para CINE 1:

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 6
ALIGN THE TOP EDGE OF THE IMAGE TO THE WIDTH OF THE SCREEN
The top edge of the image is too wide
Turn the two front levelling feet out
a little, until the lateral edges of the
image are parallel to the edges of the
screen
The top edge of the image is too narrow
Turn the two rear levelling feet out
a little, until the lateral edges of the
image are parallel to the edges of the
screen
Place the device slightly further away
from the screen to enlarge the image
to the width of the screen
Should the two rear levelling feet have
reached their max. height and cannot be
turned out more, then you can try turn-
ing in the two front levelling feet instead.
MEDIA SOURCES
NETWORK
CABLE CONNECTION (LAN)
Connect the LAN port on the rear of the device with an external modem or
router via a LAN cable (Ethernet Cat 5)
Router
(DHCP)
Cine 1
WIRELESS CONNECTION (WLAN)
The Laser TV can be connected wirelessly to a WLAN network. This will require
a Wi-Fi router or a wireless modem.
Access the setup assistant in the device menu
Follow the instructions provided
router (DHCP)
Cine 1
Notes
• Using the device with wireless networks requires the activation of the inte-
grated WLAN module. External USB network adapters are not supported.
• Connecting to a wireless network is a lot easier if the router used supports
DHCP.
• The device supports the following security standards: WEP, WPA, WPA2.
• For optimal reception, the distance between router and the Laser TV should
not exceed 10 m / 33 ft.
USB CONNECTION
When connecting an external drive or a USB hub, the power supply of the
connected device should always be used. Exceeding the total power usage
can result in damage. The max. permissible power usage of the USB 1.1 and
USB 2.0 devices is 500 mA. The USB port supports a max. voltage of 5 V.
Note
• Some non-standard high-capacity drives may cause the Laser TV to reboot
or self-lock if their surge current is greater than or equal to 1 A. This device
does not support these types of external drives.
ADSL/VDSL Modem
Cable TV
Wi-Fi

Publicidad

loading