- Connect the mains plug only when the tool is switched o . After using, pull the mains plug.
- Always direct the cable to the rear away from the machine.
- Do not carry the machine by the cable.
- When working with the machine, always hold it rmly with both hands and provide for a
secure stance.
- During pauses in the work, when not in use or during work on the machine itself (e.g., chan-
ging of the working tools, repairs, cleaning, adjustment), pull the mains plug.
- Persons under 16 year of age are not permitted to operate this machine.
- Keep the tool accessories out of the reach of children.
- Only use original accessories.
Before Use
Be careful of hidden electrical lines or gas and water pipes. Check the working
area, e.g. with a metal detector.
Always use the correct supply voltage!
The voltage of the power source must agree with the value given on the nameplate of the ma-
chine.
Tool Changing
Take care that the dust protection cap 3 is not damaged when changing tools.
SDS-max Tools
The SDS-plus tool is designed to be freely movable. This causes eccentricity when the machine
is o oad. However, the drill automatically centres itself during operation. This does not a ect
drilling precision.
Inserting
Clean and lightly the tool before inserting.
Insert the dust-free tool into the tool holder 2 with twisting until it latches.
The tool locks itself. Check the locking by pulling on the tool.
Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
6