Siefken SD2631 Instrucciones página 24

Built to Exceed 3 YEARS
L I M I T E D WA R R A N T Y
Operating Modes
Warning!
When switching operation modes， Please trigger
ON/OFF switch slightly.
1. Hammer drill mode:
Turn the mode selector switch 7 to " "(see Fig.1),
2. Chisel mode
Turn the mode selector switch 7 to the " "direc-
tion. (see Fig.2)
3. Changing the chiselling position (see Fig. 3）
The chisel can be locked in 8 positions. In this
manner, the optimum working position can be set
for each application. Insert the chisel into the tool
holder. Adjust to the desired angle of chisel bit,
then switch back to chisel mode.
8